• Company Name: Jiangsu Weier Furnace Industry Co., LTD
  • Contact: Zhu Haojun
  • Mobile: +86-13776484848
  • Tel: +86-511-88031666
  • Fax: +86-511-88031667
  • E-mail: jswely@163.com
  • Address: Development Zone, Jiangsu Province, Danyang Li Zhuang

PRODUCT CATEGORIES

Weier Furnace began as a service company and our commitment to service remains an integral part of our culture.
It has served to make us the premiere supplier of industrial furnace replacement parts and components, service and repair and service consulting service.
“The turn around time was above and beyond anything I had expected.” “It’s reassuring there are companies today who meet and exceed their customers’ expectations while producing a quality product”.
The product, the service, the communication and consistent professionalism at every level of the company is my gold standard for project realization.

Your current location:Jiangsu Weier Furnace Industry Co., LTD >> News Center >> Car-safety operating requirements of salt furnace

Car-safety operating requirements of salt furnace
(1) must be installed ventilation equipment to remove salt, steam and other toxic gases. Workpiece should wear protective glasses, gloves and wear work clothes.
(2) to add a new bath salt and deoxidizer, should be completely dry, in batches, adding a small amount gradually. Workpiece and fixture mounted blast furnace should be fully dried. Workpiece to the nitrate should be added to remove the oil. Low-temperature salt water, when required, should be added at room temperature.
(3) salt composition before and after the process used should be compatible, the procedure of a small amount of salt into the salt bath in the next procedure, should not lead to salt deterioration or explosion. Into nitrate in the nitrate is strictly prohibited. In the high-temperature salt, cyanide salts, nitrate in the operation, should be separately using a dedicated tool kit.
(4), toxic, explosive, corrosive or hygroscopic bath agents, such as cyanide salts, nitrate, barium chloride and alkali, etc., should be required in specific locations, with special container packaging store, kept by hand.
(5) bath furnace should be available near the fire-fighting equipment and emergency medicine. Operators should be trained. Application of dry sand bath heater fire fighting, water and aqueous solutions can not be put out, so as not to splash or cause fire to spread salt.
(6) abandoned toxic agent exposure to salt used tool kit, containers, overalls and gloves should be disinfected. Required with a cyanide salt waste ferrous sulfate, hydrated lime and water solution to disinfect the preparation, soak 30min stirring, then the static bubble 3h. Usually sulfuric acid waste lye and disinfected.